RUSP build, page 12, stage 4
Posted: Sun May 12, 2024 2:39 pm
Hi. I have a question as to the fastening of the bell arm to the daughterboard, the kit was a couple of m2 screws short, but after locating two spare ones (tip- check all boxes and drawers, chances are some might just hang around in the corners buried in fluff) I have noticed that the daughterboard has nylon washer and nut prefixed, is this an upgrade on the daughterboard that deviates from the manual, or am I in some other way daft? So no nylstop nut on this one?
As an aside, really good project to do with both young and adult kids, the cool wonkiness of this project captivates their attention!
Cheers, sturla
As an aside, really good project to do with both young and adult kids, the cool wonkiness of this project captivates their attention!
Cheers, sturla